|
12volts
|
wht/blue (50A), wht/red (30A) |
+ |
ignition harness |
|
Starter
|
green/black |
+ |
ignition harness |
|
Second Starter
|
black/white |
+ |
ignition harness |
|
Ignition
|
black/red |
+ |
ignition harness |
|
Second Ignition
|
blue/yellow |
+ |
ignition harness |
|
Third Ignition
|
N/A |
|
|
|
Accessory
|
white/green |
+ |
ignition harness |
|
Second Accessory
|
N/A |
|
|
| Keysense |
green/black |
- |
ignition harness |
| Notes: Using the status output from the remote
start to trigger this wire will disarm the factory alarm without
unlocking the doors. |
|
Power Lock
|
purple |
- |
driver kick, 10 pin plug, pin 4 |
| Notes: Meter this wire while turning the key in
the driver door key cylinder. |
|
Power Unlock
|
green/black (double pulse) |
- |
driver kick, 10 pin plug, pin 8 |
Notes: Meter this wire while turning the key in
the driver door key cylinder.
Can also use the passenger
door key cylinder unlock wire, which only requires a single
pulse. It is pink (-), in the passenger kick, 10 pin plug, pin
4. |
|
Lock Motor
|
blue/red |
5wi |
driver kick, 12 pin plug, pin 10 |
|
Unlock Motor
|
blue/black |
5wi |
driver kick, 10 pin plug, pin 9 |
|
Parking Lights+
|
green |
+ |
fuse box, 13 pin plug, pin 10 |
|
Parking Lights-
|
green |
- |
headlight switch or BECU, pin 13 |
| Notes: The Body ECU is attached to the back of
the fuse box. It has a single 26 pin plug. |
| Hazards |
red/white or white |
- |
switch or turn signal flasher,pin 10 |
| Notes: The turn signal flasher is behind the
fuse box. |
| Turn Signal(L) |
red/black (F), blue/black (R) |
+ |
turn signal flasher, pins 4 and 5 |
Notes: The turn signal flasher is behind the
fuse box.
On models without daytime running lights, the
blue/black triggers the front and rear turn signals. |
| Turn Signal(R) |
red/yellow (F), blue/yellow(R) |
+ |
turn signal flasher, pins 2 and 3 |
Notes: The turn signal flasher is behind the
fuse box.
On models without daytime running lights, the
blue/yellow triggers the front and rear turn signals. |
| Reverse Light |
red/white |
+ |
driver kick, gray 12 pin plug, pin 1 |
|
Door Trigger
|
green/white (ajar indicator) |
- |
instrument cluster or BECU, pin 4 |
Notes: The Body ECU is attached to the back of
the fuse box. It has a single 26 pin plug.
The individual
door trigger wires are at the fuse box. The LF door is
green/yellow in an 18 pin plug, pin 7. The RF door is red/black
in a 22 pin plug on the back, pin 8. The rear doors are
pink/black in an 18 pin plug, pin 6. Use all three wires and
diode isolate each. |
|
Dome Supervision
|
blue |
- |
fuse box, black 13 pin plug, pin 9 |
|
Trunk/Hatch Pin
|
N/A |
|
|
|
Hood Pin
|
N/A |
|
|
|
Trunk/Hatch Release
|
N/A |
|
|
| Power Sliding Door |
N/A |
|
|
|
Factory Alarm Arm
|
arms with lock |
|
|
|
Factory Alarm Disarm
|
disarms with unlock |
|
|
|
Disarm No Unlock
|
use key sense wire |
|
|
|
Tachometer
|
black/white |
ac |
data link connector, pin 9 |
Notes: The data link connector is under the
driver side dash.
Also found at the ECM behind the glove
box, second plug from the bottom, pin 1. |
| Wait to start |
N/A |
|
|
|
Brake Wire
|
blue |
+ |
fuse box, 11 pin plug, pin 2 |
| Parking Brake |
green/yellow |
- |
fuse box, 18 pin plug, pin 5 |
|
Horn Trigger
|
green/red |
- |
fuse box, 18 pin plug, pin 10 |
| Memory Seat 1 |
N/A |
|
|
| Memory Seat 2 |
N/A |
|
|
| Memory Seat 3 |
N/A |
|
|
| Immobilizer Bypass Module: |
Required: Yes |
Type: Transponder |
Part #: 556U or 555U |
| Notes: Standard on V6 models. |
This wiring information is being
provided free of charge on an "as is" basis, without any
representation or warranty. It is your responsibility to verify
any circuit before interfacing with it using a digital
multimeter.
Directed electronics, Inc. assumes no
responsibility with regards to the accuracy or currency of this
information. Proper installation in every case is and remains
the responsibility of the installer. DEI assumes no liability or
responsibility resulting from improper installation, even in
reliance upon this information. |