|
12volts
|
white (40A), yellow (30A) |
+ |
ignition harness |
|
Starter
|
black/white |
+ |
ignition harness |
|
Second Starter
|
black |
+ |
ignition harness |
|
Ignition
|
gray |
+ |
ignition harness |
|
Second Ignition
|
green |
+ |
ignition harness |
|
Third Ignition
|
N/A |
|
|
|
Accessory
|
blue |
+ |
ignition harness |
|
Second Accessory
|
N/A |
|
|
| Keysense |
green |
- |
ign harn or BECU, 2nd plg dwn, pin 2 |
Notes: Using the status output from the
remote start to trigger this wire will disarm the
alarm without unlocking the doors.
The BECU (Body ECU) is
behind the glove box, it is the module to the right. |
|
Power Lock
|
see DirectFax document 1070 |
|
|
Notes: The driver side wires are at the driver door
module in the door. They are: lock - green in pin 4, unlock - yellow in
pin 14, and lock detection - brown in pin 16.
The passenger side
wires are at the BECU behind the glove box, 2nd plug down from the top.
They are: lock - purple in pin 8, unlock - lt. blue in pin 13, and lock
detection - brown in pin 11. |
|
Power Unlock
|
see power lock notes |
|
|
|
Lock Motor
|
blue |
5wi |
BECU, bottom plug, pin 1 |
| Notes: The BECU (Body ECU) is behind the glove box, it
is the module to the right. |
|
Unlock Motor
|
brown |
5wi |
BECU, bottom plug, pin 2 |
| Notes: The BECU (Body ECU) is behind the glove box, it
is the module to the right. |
|
Parking Lights+
|
white to brown |
+ |
driver kick, 20 pin plug, pin 8 |
|
Parking Lights-
|
purple |
- |
switch or BECU, 2nd plug dwn, pin 18 |
| Notes: The BECU (Body ECU) is behind the glove box, it
is the module to the right. |
| Hazards |
orange |
- |
turn signal flasher left of column |
Notes: Also found blue (-) at the BECU, top plug, pin
19.
The BECU (Body ECU) is behind the glove box, it is the module
to the right. |
| Turn Signal(L) |
red |
+ |
turn signal flasher left of column |
| Turn Signal(R) |
blue |
+ |
turn signal flasher left of column |
| Reverse Light |
red/black to pink |
+ |
driver kick, 14 pin plug, pin 10 |
|
Door Trigger
|
see notes |
- |
BECU behind glovebox, module to R |
| Notes: The driver door trigger is black in the 3rd plug
down, pin 11. The front passenger door is lt. blue in the bottom plug,
pin 16. The rear door trigger wire is lt. green in the bottom plug, pin
15. Use all three wires and
diode isolate each. |
|
Dome Supervision
|
green |
- |
ignition key cylinder illumination |
Notes: Also found brown (-) at the BECU, bottom plug,
pin 11.
The BECU (Body ECU) is behind the glove box, it is the
module to the right. |
|
Trunk/Hatch Pin
|
green |
- |
BECU, 3rd plug down, pin 6 |
| Notes: The BECU (Body ECU) is behind the glove box, it
is the module to the right. |
|
Hood Pin
|
green/black to white |
- |
pin switch or Theft ECU, pin 34 |
| Notes: The Theft Deterrent ECU is behind the glove box. |
|
Trunk/Hatch Release
|
N/A |
|
|
| Power Sliding Door |
N/A |
|
|
|
Factory Alarm Arm
|
arms with lock |
|
|
|
Factory Alarm Disarm
|
disarms with unlock |
|
|
|
Disarm No Unlock
|
use key sense wire |
|
|
|
Tachometer
|
black |
ac |
ECM, top plug, pin 5 |
Notes: On the 6 cylinder models, the tach wire is in the
2nd plug down, pin 1.
The ECM (Engine Control Module) is behind
the glove box, it is the module to the left.
The tach wire is
also found at the data link connector, pin 9, under the driver side
dash. |
| Wait to start |
N/A |
|
|
|
Brake Wire
|
black |
+ |
brake pedal switch |
| Parking Brake |
black |
- |
parking brake switch |
|
Horn Trigger
|
pink |
- |
switch or BECU, bottom plug, pin 10 |