رينو
1. Igniton ON
2. Press and hold the central locking button for 5 seconds
3. LED on the dash board will go off, come back on and begin to flash. The flashes correspond to
the first digit of the 4 PIN security code- release the button when the first digit has been
"flashed" and then press the button again.
4. Wait for the second digit to be "flashed" then release and re-press the button- continue until all
digits have been entered.
5. If you have entered the code correctly the LED will then go out and the car can be started- to
code the remote, switch off the ignition and press the central locking button again.
6. Press remote button 2 times within the immediate vicinity of the pick up (in the roof) On some
vehicles you may need to switch the ignition back on to achieve this however.

هوندا
Programming of Infra Red remote controls.
NOTE : Maximum of 3 can be programmed.
NOTE : Please ensure time delays are maintained, otherwise procedure will not be completed correctly.
Procedure
1. Turn ignition ON.
2. Within 4 seconds push the transmitter button aiming the transmitter at the receiver unit above the
rear view mirror.
3. Within 4 second turn ignition OFF.
4. For additional remote controls repeat steps 1 to 4 within 4 seconds of programming the last remote
control.
5. Turn ignition ON.
6. Within 4 seconds push the transmitter button aiming the transmitter at the receiver unit above the
rear view mirror.
7. The door actuator should operate.
8. Within 8 seconds aim the first remote control at the receiver and press the transmitter button.
9. The door actuator should operate.
10. Within 8 seconds aim the second remote control at the receiver and press the transmitter button.
11. The door actuator should operate.
12. Within 8 seconds aim the third remote control at the receiver and press the transmitter button.
13. Turn ignition OFF, and remove key.
14. Confirm all remote controls operate.
11
11

مازدا
REMOTE CONTROL PROGRAMMING
626
1. Make sure the drivers side door is open.
2. Turn Ignition ON, and then back OFF.
3. Remove the key , and then repeat steps 1-2 2 more times.
4. Press the light switch that operates the courtesy light on the drivers door A post, and make
sure the light goes out. Repeat this 2 times.
5. When the car makes a beep sound, press the Lock button on the remote control 2 times, the
car should make a beep sound.
6. Repeat for additional remote

ايضا هناك طرق يدويه لاعاده تعريف وبرمجه الامبولايزر بشكل يدوي
وشكرا

انا فقدت التحكم بالريموت كنترول بعد فصل البطارية عن السيارة (شيري كيو كيو )
واستعدت الريموت كنترول لمفتاح واحد فقط كما يلي:
ادخل المفتاح في مكان تشغيل السيارة
ادر مفتاح ليضيئ تابلو السيارة ثم اعد المفتاح ليطفئ التابلو ثلاث مرات متتالية سوف يضيئ ضوء السيكيورتي الموجود بجانب زر الطوارء (الرباعي) عندها اضغط على الزرين الموجودين على مفتاح الريمونت كنترول لمدة 3ثوان وسوف يعمل المفتاح

على ما اعتقد ان المفتاحين سوف يعملان معا اذ ضغطت على الزرين (اللوك والانلوك ) في المفتاحين معا