[م/ طوني جعجع]

الموضوع منقول للأمانة .

تحية الكم جميعا بعد غياب طويل بدواعي الاستقرار باميركا ومن ثم العودة للسعودية ولبنان
Dessign & Engineering For United Smat

UNITED SMAT’s experienced engineering team brings you the highest value solution for any cooling tower application. Every solution is custom

designed fresh: We make sure our cooling towers meet all required technical specifications, and do so in the most cost-efficient and easy-to-operate fashion. We will:

Provide you with CAD drawings in 2- or 3-D models for every project. Offer you P&ID whenever complexity of the cooling system(s)
so requires.
Run computerized thermal ratings and performance tests with
your figures, including “What If?” scenarios.
Adjust our solution to existing conditions on site, such as existing concrete water basin, space constraints, and existing equipment (e.g., pumps, piping, motors).
quality, and composition.

UNIED SMAT’s engineering team will work with you closely throughout the process of designing, budgeting, and planning your cooling tower until the right solution is targeted.
Marcool COOLING TOWER - أبراج التبريد
ct*marcool-sa.com
Made In K.S.A

MARCOOL
MARCOOL INDUSTRIES
MARCOOL
شركة محمد الشهري ورشيد جمجوم للصناعة
www.marcool-sa.com

[م/ طوني جعجع]

COOLING SYSTEMS

Air Distribution Systems ( DUCT (

towerthat workswith ammonia.
The cooling towerindustryisin a factorythe company
In Saudi Arabia - Jeddah

شركة محمد الشهري ورشيد جمجوم للصناعة ( ماركول )
’ِMARCOOL
Heat Transfer
UNITED SMAT COOLING TOWER JEDDAH SAUDI ARABIA

صناعة برج التبريد بشركة ماركول
برج تبريد بالأمونيا
الدائرة المغلقة الرطبة .


Ammonia Refrigeration – How It Differs

"How does ammonia refrigeration work?" Yes, it is different from refrigeration and air-conditioning using halocarbon refrigerants. But there are a lot of similarities also. So let’s start with some basics – a short review of vapor-compression refrigeration, native to all refrigerants. I’m going to leave out any discussion of ammonia/water absorption (heat-driven) cycles and limit this discussion to cycles involving vapor-compression.

The Bare Bones Basics
Every vapor-compression refrigeration system or unit ever built will have at least one each of these four components:
compressor
condenser
expansion device
evaporator
Figure 1 illustrates these components and their relative placement with one another.
Figure 1 – Basic Vapor-Compression Refrigeration Cycle

The line numbers denote:
Hot gas (high pressure, high temperature)
Liquid (high pressure, warm temperature)
Liquid + vapor (low pressure, cold temperature)
Vapor (low pressure, cold temperature + ~10 ºF superheat)


ماركول
مصنع ماركول

Marcool
www.marcool-sa.com